Oil, Gas, & Energy Services Overview

  • Compression Engineering & Design
    • Mechanical and Process Engineering and Design
    • Electrical and Instrumentation Engineering and Design
    • Control Systems Engineering, Design, and Programming
    • Development and Creation of Project Justification and Scope of Work
    • Compressor and Engine Selection
    • Project Estimates
    • Compression Design Packages
    • Bid Packages and Construction Support
    • Project Walk-downs
    • Project Engineering
    • CADD Design (2D and 3D)
    • Planning and Scheduling Support
    • Material Procurement and Requisitioning
    • Troubleshooting
  • Pipeline and M&R Engineering and Design
    • Pipeline Route Selection and Surveys
    • Pipeline Engineering and Design
    • Measurement and Regulation Engineering and Design
    • Alignment Sheet Preparation
    • Permit Drawings
    • Class Location Studies
    • MAOP Determination and Upgrade Studies
    • Integrity Management – Launcher/Receiver Design
    • Regulatory Plans – Emergency/Damage Prevention/Op Qual/IMP
  • Operation and Maintenance support
    • Operation and Maintenance Plans
    • Facility Audit and Review
    • Root Cause Analysis
    • Problem Determination
    • Performance Analysis
    • Maintenance Analysis
    • Compressor Station and Unit Reliability Assessments
    • Compressor Operating Curves
  • Pipeline Simulation Software Support
    • Stoner Compressor / Station Modeling
  • Training
    • Reciprocating Engine and Compressor
    • Gas Turbine and Centrifugal Compressor
    • Dehy Systems
    • Station Controls and Auxiliary Systems
  • Emission Reduction Projects
    • Catalyst Selection and Installation
    • Catalyst Monitoring Systems
    • Ignition System Upgrades
  • Construction, Pre-commissioning and Commissioning support
    • Onsite Project Management / Project Lead / Resident Engineering
    • Start-up and Commissioning Planning, and On-site Commissioning Support
    • Engineering Support and Coordination of Sub-contractors Activities During Construction
  • Structure Design
    • Concrete Foundations
    • Mechanical Supports
    • Platforms and Cranes
    • Load ratings (floor, shelf)
    • Special Tool Certifications
    • Epoxy Grout Engineering
    • Cable Tray Supports
    • Building Code Permits
    • Bridge Design
  • Site Design and Survey
    • Pipeline Surveys
    • Grading Plans
    • Roadway Design
    • Property Plat Surveys
    • Contour Surveys
    • Flood Plain Studies
  • Environmental
    • Air Permitting and Compliance Assistance
    • Spill Prevention Control and Countermeasure (SPCC) Plans
    • Groundwater Protection Plans and Spill Prevention Reports (Chemical Bulk Storage)
    • ESCGP-1 and Storm-water Permit Applications
    • Impoundment Design
    • Erosion and Sediment Control Plans

Classroom Training

  • Reciprocating Engine
  • Reciprocating Compressor
  • Gas Turbine
  • Centrifugal Compressor
  • Dehydration Unit
  • Station Auxiliary Systems

Contact Us


L.A. Gates Company

500-A Prestige Park Drive,
Hurricane, West Virginia 25526.
 
Headed by:Gary Keaton, P.E.
Telephone:304.256.1640 ext 110
FAX:304.256.1617
E-mail:gkeaton@lagates.com